Williams Sound WIR RX6 Guide d'installation télécharger pdf (Page 6)

Williams Sound

Helping People Hear

INSTALLATION PROCEDURE

INSTALLATION STEP 1: TX8 EMITTER SET-UP

SELECTING A

MOUNTING LOCATION

The most important principle to understand when installing the TX800 system is that invisible infrared

light behaves just like visible light. It does not pass through opaque objects such as walls, curtains, or

people. It does pass through windows and door openings and can bounce and scatter off reflective walls,

floors, and ceilings. Therefore, the infrared emitter panels should not be concealed or covered, nor should

the infrared “eye” on receiver units be covered. Receivers work best with a clear line-of-sight to the

emitter panels.

The TX8 Infrared Emitter should not be installed outdoors, or where there is a lot of direct sunlight

indoors. Sunlight generates infrared interference. Certain types of high-efficiency lighting fixtures can also

generate interference at 95 kHz because they use high frequency modulation.

MOUNTING THE TX8 TO A WALL OR CEILING:

Step 1: Using the mounting plate (Figure 2A) as a template, mark the hole locations on the mounting surface

where the TX8 will be installed. See Page 7, Figure 2B for optional mounting positions.

Step 2: Locate the top mounting hole in the rear of the TX8 emitter. Gently screw the male end of the swivel

head on to the emitter. Tighten the swivel head tension screw: turn clockwise until the connection is secure.

Step 3: Screw the male end of the shaft into the female end of the swivel head. An additional shaft can be

added to create more distance between the wall/ceiling and Emitter.

Step 4: Place the plate cover snugly over the mounting plate. This will hide the screws after installation.

Step 5: Screw the male end of the mounting plate into the female end of the shaft. For suspended ceilings, screw

the female end of the shaft into the male end of the T-Bar clip. The mounting bracket is now installed on to

the TX8 Emitter.

Step 6: Position the TX8 Emitter and BKT 024 so the mounting plate lines up with the marked holes on the

mounting surface. Fasten the mounting plate to the surface using screws and wall anchors. Mounting

the TX8 to a Suspended Ceiling with Cross Tee: Fasten the T-Bar clip on to the desired Cross Tee.

Step 7: Position the TX8 Emitter to the desired angle: Begin by gently turning the tension screw (Figure 2A) counter

clockwise to release the swivel head. Adjust the TX8 to the desired angle. When the TX8 is in the desired

position, gently turn the tension screw clockwise until the swivel head is securely in place.

FIG. 2A: BRACKET 024 MOUNTING

TX8 Emitter

Swivel Head

tension screw

Shaft

(optional)

Shaft Plate

Cover

Mounting

Plate

Mounting

Screws

(To Wall or Ceiling)

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Williams Sound WIR RX6 Guide d'installation Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteur Williams Sound WIR RX6