Williams Sound WIR RX6 Guide d'installation télécharger pdf (Page 19)

Williams Sound

Helping People Hear

RECEIVER INSTRUCTIONS

TWO CHANNEL IR RECEIVER MODEL WIR RX5

Make sure the “eye” on the front of the receiver is not covered up when in use. The receiver

is intended to be worn on the front of the body, hanging from the lanyard attached to the

receiver. The receiver will not work if it is placed in a pocket or purse. A variety of

earphones, headphones, or a neckloop telecoil coupler can be used with the RX5 Receiver.

Step 1: To install the batteries, open the battery compartment using a coin in the slot in the

bottom of the receiver. Press two AA batteries into place, observing proper battery

polarity.

Step 2: Plug the earphone or headphone into the earphone jack.

Step 3: Turn the receiver on by rotating the volume control knob clockwise.

Step 4: Choose the appropriate channel using the push-button channel selector.

Step 5: Adjust the tone to your preference using the slide switch tone control. To avoid

draining the battery, make sure the receiver is turned off when not in use.

STEREO IR RECEIVER MODEL WIR RX6

Make sure the“eye” on the front of the receiver is not covered up when in use. The receiver

is intended to be worn on the front of the body, hanging from the lanyard attached to the

receiver. The receiver will not work if it is placed in a pocket or purse.

A variety of stereo earphones and headphones can be used with the RX6 Receiver.

Step 1: To install the batteries, open the battery compartment using a coin in the slot in the

bottom of the receiver. Press two AA batteries into place, observing proper battery

polarity.

Step 2: Plug the earphone or headphone into the earphone jack.

Step 3: Turn the receiver on by rotating the volume control knob clockwise.

Step 4: Adjust the tone to your preference using the slide switch tone control. To avoid

draining the battery, make sure the receiver is turned off when not in use.

!! IMPORTANT WARNINGS !!

DO NOT ATTEMPT TO RECHARGE ZINC CARBON (“HEAVY DUTY”), ALKALINE, OR

LITHIUM BATTERIES!

DO NOT ATTEMPT TO RECHARGE SINGLE-USE BATTERIES!

These batteries may heat up

and explode, causing possible injury and damage to the equipment.

Avoid shorting the plus and minus battery terminals together with metal objects. Battery

damage and burns can result!

Use only Williams Sound supplied chargers and batteries!

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Williams Sound WIR RX6 Guide d'installation Page 19